Dev Board: VCC-GND ESP32-S3-WROOM-1U-N16R8 dev board
Port: USB-CH343
Arduino IDE version:2.3.2
TFT_eSPI version: 2.5.43
LCD module: 320*480 module with ST7796S

[code]Backtrace: 0x42003628:0x3fcebf��x���x��������������xx�����x����xxxxx�������x�������x��x�x�����x����xxxxx������x�����������x��������x����xxxxx�����x�xx�xx�xx�xx�xxx�xx���x��x�xxx���x�xx��x����������x����x�x��x��x�x������xx�x�x���x��xx�x��xx�xx�x�x�x��x�x�xx�x�xx�x�ESP-ROM:esp32s3-20210327
Build:Mar 27 2021
rst:0xc (RTC_SW_CPU_RST),boot:0x8 (SPI_FAST_FLASH_BOOT)
Saved PC:0x403796b2
SPIWP:0xee
mode:DIO, clock div:1
load:0x3fce3818,len:0x508
load:0x403c9700,len:0x4
load:0x403c9704,len:0xad0
load:0x403cc700,len:0x29e4
entry 0x403c9880
Guru Meditation Error: Core 1 panic'ed (StoreProhibited). Exception was unhandled.

Core 1 register dump:
PC : 0x4200362b PS : 0x00060c30 A0 : 0x820036b8 A1 : 0x3fcebff0
A2 : 0x00000010 A3 : 0x00000000 A4 : 0x60004000 A5 : 0x0000000d
A6 : 0x000000ff A7 : 0x00000000 A8 : 0x08000000 A9 : 0x3fcebfc0
A10 : 0x3fc95810 A11 : 0x00000001 A12 : 0x019bfcc0 A13 : 0xffffffff
A14 : 0x00000031 A15 : 0x00000000 SAR : 0x00000002 EXCCAUSE: 0x0000001d
EXCVADDR: 0x00000010 LBEG : 0x420073b4 LEND : 0x420073fb LCOUNT : 0x00000000[/code]

The above is the output of Serial monitor, I directly flashes the program without modifying nor including the User_Setup.h. Could anybody tell me what is going on? Thanks!