... REMOVAL WINDSHIELD DEFLECTOR ASSEMBLY ( AVIM ) . Refer to paragraphs 2-489 and 2- 491 . 2-487 . REPAIR - WINDSHIELD DEFLECTOR ASSEMBLY . a . Paint deterioration superficial paint scratches repair ... template using a hole finder . Align ...
... replacement is required , use removed wiring as template to determine length required for new wiring . 3-28 . Domelight . Service is limited to replacement of lamp . If replace- ment lamp does not work , check circuit breaker . Place ...
... Removal – Lower Cutter Assembly. Support cutter when removing the last few ... Repair — Lower Cutter Assembly. Paint deterioration or superficial paint ... template. b. Position the template on top of panel (5), and cleco together ...
... Removal - Navigation Lights. a. Check that all electrical power is OFF. b ... Repair or Replacement - Navigation Lights. Replace faulty or damaged component ... template over the center point of the cut stencil hoard (lengthwise) and ...
... template . If front or rear panel supporting angles are new , use hose bed as a drill template . C. Front Panel Assembly Repair NOTE Remove ... removal , the lockbolts that secure the hose bed to the support angles have already been removed ...
... removal of drag strut ( 15 , figure 5-17A ) may be made by removing at ... repair . Refer to paragraph 5-5G before starting any repair . - Grease pencils shall ... template ( kit ) on the blade . Posi- tion the inner circle to enclose the ...
... template paper ( C234 ) . Align one edge of the paper with the blade trailing edge . ( b ) Draw the outline of the area to be removed on the paper . Use a pencil , a compass , and a straightedge , if required . area . ( c ) Remove the ...
... Repair . Repair the bench assembly as follows : ( 1 ) Door Handles and Latching Mech- anism . Replace door handles and ... template using the removal bench as a pattern . ( 2 ) Drill the replacement bench attachment bolt holes using the ...
... template from 0.012 - inch alumi- num alloy , 2024 - T3 ( item 2 , table 19-1 ) , to fit each leg of angle . ( 2 ) Clamp and back drill rivet holes in templates . ( 3 ) Mark each template for identification , remove clamps , and transfer ...
... Remove burs . Use base of template ( thick section , fig . 3-7 ) to determine con- centricity . f . Repair of " Pulled - Out " insert in transmission trunnion support welded to hull . Replace the " pulled- out " insert as follows : ( 1 ) ...